Installing the heater in the JUWEL filter system
The JUWEL aquarium heater is supplied with the heater holder (fig. 1) which you will
need for the installation.
Please perform the following steps for all JUWEL Aquarium filter systems:
(You may need to start by removing an installed separation wall holder.)
1. Install the heater holder.
2. Attach the heater to the filter housing on the inside of the filter and/or initially
insert the heater holder into the guide rail of the separation wall.
The heater is properly positioned if the heater holder rests on the upper edge of the
housing and/or the separation wall.
The heater is now operational.
Recommendation:
The JUWEL automatic heater warms the water of your aquarium up to 28°C
depending on a nomal room temperature of 21°C. If you keep your aquarium in
rooms below this or your fish need a higher temperature, we recommend to
purchase a second heater.
Safety instructions:
Only connect the heater once the aquarium is filled with water at least to the
minimum water level of the heater.
Never use the heater outside the aquarium.
Operate the heater indoors only.
Operation of the heater
The JUWEL Aquarium heater has an adjuster on the top to allow individual adjustment
of the temperature to suit your own requirements.
In order to set the heater, turn the adjuster until the temperature indicator
corresponds to the required temperature value.
It can take up to twelve hours for the water to reach the desired temperature
depending on your ambient room temperature. Thereafter the heater will maintain the
desired temperature automatically clicking on and off as required. When the heater is
heating a small red light can be seen from the top of the filter box.
We recommend that you check your water temperature with a separate thermometer.
Please check your heater frequently for any signs of damage and replace immediately if
any are discovered. No other maintenance of the heater is required.
Recommendation
JUWEL Digital Thermometer
To monitor the temperature we recommend the JUWEL Digital Thermometer (Part No.
85701). Available from your JUWEL Aquarium retailer.
Safety instructions:
Always unplug the heater and allow it to cool before removing it from the filter.
Never attempt to open or repair the heater. Any signs of damage or malfunction
and the heater should be replaced with an original JUWEL Aquarium heater.
Never repair the electrical cord or plug. In case of damage replace the complete
heater.
Once removed never place on a flammable surface.
This appliance is not intended for use by young children or infirm persons unless
they have been adequately supervised by a responsible person to ensure that
they can use the appliance safely. Young children should be supervised to ensure
that they do not play with the appliance.
7
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals